There are many problems in the use of the emulsifier, which requires maintenance and repair, and repairs require professional maintenance personnel, but many users do not have professional maintenance personnel, so the maintenance of the emulsifier is also an important factor for the user. .
Here is a brief introduction to the maintenance and disassembly steps of the emulsifier:
1. Remove the locking nut of the rotor of the working head of the emulsifier. Rotate the nut counterclockwise with a socket wrench or a wrench.
2, remove the rotor, gasket
3. Use a socket wrench and other wrenches to clamp the nut on the stator connector, and unscrew it counterclockwise to remove the stator.
4. Unscrew the nut of the emulsifier connecting rod with a wrench
5. Pull down the bearing housing. If there is a jam, gently shake the bearing seat and gently remove it. If the bearing housing is stuck, gently tap along the outer edge of the flange and slowly remove it.
6. Turn the bearing housing over (the original side facing down), take a column-like object or a tubular object smaller than the outer diameter of the copper sleeve and larger than the inner diameter, place it vertically on the end face of the copper sleeve, press or hammer the tube, and take the bearing from Remove from the bearing housing.
7. Take a cylinder or tubular object with an outer diameter equal to the outer diameter of the fixed pin, and place it vertically at the end of the fixed pin. Appropriately force the connecting pin of the drive shaft and the motor shaft to connect the bushing. Use a suitable method to evenly apply the force to the shaft. The sleeve is withdrawn from the motor shaft or removed from the drive shaft.
 
Keywords laboratory emulsifier laboratory disperser static mixers basket mill