If the laboratory high shear emulsifier is not used in a long time, it should be checked before the use of all the parts of the machine. We should pay attention to the electrical safety, connect the power supply and start the motor to see if there is any abnormal. If there are exceptions, the machine can be detected by the ohm table. There is no short circuit or other anomalies.
The laboratory emulsifier should turn off the power supply after stopping work. If it is no longer used in a short time, it should pull out the plug and complete the power failure. Clean every part on the head in time and keep it clean and tidy for use next time.
When we use the machine, we must avoid the empty machine running, so as to avoid the rotor bearing because of high speed rotation burning, causing unnecessary mechanical failure, so the emulsifier strictly prohibits the empty turn! After the machine is finished, the equipment must be cleaned and cleaned. For the replacement of the mesh stator, first wrench the three nuts by wrench, remove the outer stator coil, select the suitable stator assembly according to the need, then install the outer stator coil, screw the nut, tighten the fixed screw evenly, and turn the rotor shaft with the hand, check the loose phenomenon, the rotor should rotate freely.


Keywords emulsion mixer high shear mixing emulsifier static mixer